Summary:
If you notice condensation (moisture or fogging) inside your REVEAL 2.0 camera, it's important to address it quickly to prevent potential damage. Here's how to troubleshoot and resolve the issue.
1. DIY Drying Method (Recommended First Step):
This method aims to thoroughly dry out the camera and ensure all seals are clean and secure.
-
What to do:
- Power off your REVEAL 2.0 camera.
- Carefully remove the SD card, SIM card, battery tray, and external antenna (if attached).
- Place the camera in a dry location with good air circulation, such as a windowsill that receives sunlight (but not direct, intense sunlight that could overheat the camera), or near a gentle fan. Avoid using direct heat sources like hair dryers, which can cause damage.
- Allow the camera to dry out completely. This may take 24-48 hours or longer, depending on the level of moisture.
- Once thoroughly dry, inspect the rubber seals around the battery compartment and other openings. Ensure they are clean and free of dirt, debris, or damage. Gently wipe them if needed.
- Re-insert the SD card, SIM card, and battery tray. Make sure they are correctly seated.
- If you use an external antenna, ensure it is tightly screwed into its port after re-inserting the internal components.
- Power on your camera and check if the condensation is gone.
2. If DIY Method Does Not Resolve the Issue:
If the condensation persists after performing the DIY drying method, or if you suspect internal damage, email our support team at support@tactacam.com.
Important Considerations:
- External condensation often occurs in spring and fall due to temperature changes in the morning and evening. This can be easily managed with products like Rain-X Anti-Fog Wipes or "Cat Crap" Anti-Fog Balm.
- Always ensure all camera ports, battery doors, and seals are completely closed and secure when deploying your camera outdoors.
If you have any questions or need to start an RMA, please contact our customer support team at support@tactacam.com.