SK/XB Firmware Update

Here are the instructions to update the Reveal SK firmware BA07 Reveal SK Update:

1. Click on the link below and download the file.  

XB/SK FW

2. Drag the file and place it on an SD card compatible with your REVEAL camera. DO NOT put the file in a folder.
3. The File will not open with any application, it can only be read by the Reveal camera.
4. Put the SD card with the file in the REVEAL camera.
5. When you start the update DO NOT power off your camera. The update can take 5 min… when the update is finished your Reveal camera will power off and then restart.

IMPORTANT: Make sure that you have recently replaced your batteries (the device cannot lose power during this process)

6. To initiate the update, begin with the camera on ‘Off’. 

1. Press and hold the TEST button. 
2. While continuing to hold the Test button, slide the Mode slider on the left to ‘SETUP’. 
3. The status light will flash until it reboots. Once the status light starts blinking, you may let go of the TEST button. 
4. After it reboots, your update is finished.