Tactacam 2.0 camera
Step 1. After removing your new Tactacam 2.0 from its package, you must remove the Tactacam from the stabilizer by unthreading the stabilizer bolt located on the bottom of the stabilizer. The Tactacam will slide out once it’s loose. *Note – Please make sure you do this in a safe location to avoid dropping the Tactacam and causing damage.
Step 2. Once the Tactacam has been removed from both the packaging and the stabilizer, unscrew the End Cap which is on the opposite end from the Tactacam lens.
Step 3. Now that the End Cap has been removed you will see the settings of your Tactacam. Here you will want to check to make sure the battery is seated correctly by removing and reinserting firmly.
Step 4. Choose your desired settings (Photo or Video Mode/ 720p or 1080p Resolution) and insert your Micro SD Card (sold separately). The Micro SD Card should be inserted with the printed side facing the battery and the black side facing upwards towards the Photo/Video switch and mic. Screw on the End Cap and you are now ready to operate your new Tactacam.
Step 5. Install the Tactacam Stabilizer on your bow. It is recommended, once the stabilizer is snug, to give 2 more full turns and center the camera with your bow. It is important not to over tighten the rubber dampener between the bow and stabilizer. The rubber damper will help r educe vibration and keep your camera in position.
Step 6. Don't forget to register your Tactacam at https://www.tactacam.com/warranty-registration/ https://youtu.be/_gqcH8eZgSE https://youtu.be/7-dNZx282gE